How Much Do Electronics & Tech Lots in New York Cost in 2026?

Electronics Lot Prices in New York: What $1,047 to $15,290 Actually Buys

Last updated: September 2026

The live shelf on Closo Wholesale lists 16 electronics & tech lots shipping from New York, priced from $1,047 to $15,290 a lot — $10.27 to $15.29 per unit on the lots shown. That range is the floor and ceiling for anyone searching wholesale electronics new york right now. See the live shelf: Electronics & Tech lots from New York.

The spread comes down to unit count and condition mix. A $1,047 lot might carry roughly 100 mixed-condition accessories near $10.27 each, while a $15,290 lot from a supplier like Magid carries higher-value units — small appliances or smart-home devices — closer to $15 a piece.

Buyers sourcing electronics out of New York also cut freight miles versus West Coast pallets shipped east, which adds up once a several-hundred-pound lot is on a truck.

Why per-unit price moves more than lot price

As a rule of thumb, a $5,000 lot split across 400 units runs about $12.50 a piece, while the same $5,000 spread across 4,000 units lands under $1.25 a piece. Unit count, not the lot's sticker price, decides landed cost per piece.

$10,270 Lot, 1,000 Units: A Full New York Electronics Cost Breakdown

Bottom line: a mid-range New York electronics lot lands near $10.50–$10.90 per unit once freight and payment fees are added to the $10.27–$15.29 per-unit range quoted on the live shelf on Closo Wholesale. The table below walks a representative 1,000-unit lot at $10.27 a unit ($10,270 total) from list price to landed cost, the number a buyer should actually budget against for a wholesale electronics new york order.

Resale math: what a 70% sell-through actually returns

Take the same 1,000-unit lot and a conservative 70% sell-through — 700 units moved. At a $18 average resale price, a common bench figure for mixed consumer electronics, that is $12,600 in revenue against a $10,870 total landed investment, leaving roughly $1,730 before listing time and platform fees.

A supplier like Magid, one of the names on the shelf, typically runs closer to the assortment end (0 of the 16 live lots are manifested), so per-unit value inside a single lot can vary more than the average suggests — buyers should treat the $18 figure as a planning number, not a guarantee.

Quick tangent — the live shelf on Closo Seller Hub shows what is actually listed and priced right now; worth a look before your next order.

0 of 16: Why Assortment Lots Are Where Margin Actually Disappears

Bottom line: none of the 16 live New York electronics lots on Closo Wholesale are manifested, so the single biggest margin risk on a wholesale electronics new york order is buying an assortment lot as if it were a itemized one. A manifest lists every SKU and its expected condition before the buyer pays; an assortment lot only describes the category and a price.

That gap is where most of the lost margin on a first order originates, not in freight or fees.

Operators typically plan around a flat grading assumption — say 80% sellable, 20% salvage — and get burned when the real split runs closer to 65/35 on a mixed electronics pallet.

On a $10,270 lot, that 15-point miss is roughly $1,540 in units that sell for parts value instead of retail, which erases most of the margin modeled in a clean-case scenario.

Freight is the second-largest leak, and it is the one operators most often underestimate at quote time.

A lot from a supplier like Long Island Liquidation quoted at $200 flat freight can land at $350 once a liftgate fee and a residential-delivery surcharge are added — a swing of $150, or roughly 1.5% of a $10,270 lot, that rarely appears until the invoice.

The slow-mover trap

The third leak is time, not price. Consumer electronics depreciate fast — a category where a 90-day hold can cost 10-15% of resale value as newer models displace last season's stock on the shelf.

A lot that pencils out at a 70% sell-through in 30 days can slip to 50% sell-through by day 90 once a buyer is competing with Department Store Liquidations inventory moving through the same channels at a discount. Operators who model margin only at the point of purchase, without a sell-by timeline, consistently overstate the return they will actually collect.

What to check before wiring payment

Three checks close most of this gap before an order is placed. First, ask the supplier directly what share of the lot is graded versus untested — a straight answer, even an estimate like "roughly 60% tested," is worth more than silence.

Second, get the actual freight quote in writing rather than budgeting the $150–$300 rule of thumb blind, since liftgate and residential fees are the most common surprise line items.

Third, size the first order small enough to absorb a 15–20% grading miss without breaking even — a $2,000–$3,000 test lot rather than the full $10,270 range, run once through a 30-day sell-through cycle before committing to a repeat supplier.

7 Steps Before You Wire Money on a New York Electronics Lot

Bottom line: with all 16 live lots priced $1,047–$15,290 and none of them manifested, the checklist below is what separates a $1,730-margin order from a write-off on a wholesale electronics new york purchase.

1. Confirm the exact price and per-unit figure on the live shelf on Closo Wholesale before messaging a supplier — the range moves as lots sell, so a screenshot older than a day may already be stale.
2. Ask the supplier what share of the lot is tested versus untested; a supplier like Magid or Long Island Liquidation should be able to give even a rough split, such as "70% powered-on tested."
3. Get the freight quote in writing, including liftgate and residential-delivery fees, rather than budgeting the $150–$300 rule of thumb blind.
4. Size a first order at $2,000–$3,000 rather than the full range, so a 15–20% grading miss does not sink the whole purchase.
5. Request photos of the actual pallet, not stock imagery, and check for crush damage or missing shrink wrap before payment.
6. Confirm funds route through Closo escrow and release only after delivery is accepted, not on invoice.
7. Set a 30-day sell-through target before reordering, and track actual grading against the supplier's estimate to catch a pattern early.

One red flag that overrides the rest

If a supplier will not put a freight quote or a tested/untested split in writing, treat that as the single disqualifying flag regardless of how attractive the $10.27 per-unit price looks — verbal estimates are where most of the margin loss in the earlier cost breakdown originates.

Next Step: Run the $10,270 Math Against a Live New York Lot

Bottom line: with 16 live lots priced $1,047–$15,290 and a landed cost near $10.72–$10.87 per unit on a typical mid-range lot, the fastest way to test a wholesale electronics new york purchase is to price out one real listing rather than a hypothetical. Pull up the live shelf on Closo Wholesale, pick a lot inside a $2,000–$3,000 test budget, and run it through the same table used above: lot price plus freight, divided by unit count, against a conservative 70% sell-through.

A lot from a supplier like Department Store Liquidations or Magid will differ in mix, but the arithmetic does not change — landed cost per unit, resale price, sell-through timeline.

Buyers who run that math before wiring funds consistently catch the freight surprises and grading misses covered above; buyers who skip it are the ones reporting the $1,540 losses on the same category of lot.